Replacement lift handle for the RS-1105-RH.
- Material:
- Lift: Zinc die-cast, chrome plated
- Bumper: Gray, non-marking rubber
- Height
- Upper grip (textured half): 15/16"
- Lower half: 1-5/16"
- Both parts: 2-1/2"
- Depth
- Upper half
- Including mounting pegs: 1-1/2"
- Not including mounting pegs: 11/16"
- Lower half
- Including mounting pegs: 1-9/32"
- Not including mounting pegs: 9/16"
- Thickness
- Top and back edge: 5/16"
- Textured grip on upper half: 3/32"
- Grip style: 1/16" concave squares
- There are flat platforms that lay between, and perpendicular to
- the grip handle and mounting pegs, forming a base and stop for
- the mounting pegs. The flat platforms butt up against the outside
- of the door when the handle is in place. The mounting peg extends
- back off the plaforms, then to the left on a 90 degree bend and
- into the side of the lockbar.
- Platform
- Qty: 2 each, 1 under each mounting peg
- Width: 5/16"
- Length: 9/16"
- Thickness: 3/32"
- Mounting pegs
- Qty: 2 each
- Length
- To center of bend, from the platform: 7/16"
- From the center of the bend to the tip: 11/32"
- Height
- At platform: 3/8"
- At tips: 5/16"
- Width: 3/16"
- Peg to peg OC: 1-1/8"
- There are two bumpers, one between each platform and the handle
- portion, which add to keep the lift portion from clanging
- against the housing as it moves up and down.
- Width: 9/32"
- Height: 1/4"
- Depth: 3/16"
- Padlock hole dia: 3/8"
(Only registered customers can rate)
There are no comments for this product.